Fisher Labs 1280-X Instrukcja Użytkownika Pobierz pdf (Strona 4)

ASSEMBLY

The 1280-X requires very little assembly. Unpack it carefully and

save the carton which may come in handy for future storage or

shipment.

1. Remove the headphone, handle and search coil

assemblies from the shipping carton. Be careful not

to damage the foam rubber inserts or put any strain

on the cable connections.

2. Adjust the stem to the approximate length you

will be using, extended for stand-up use or, as short

as possible for diving. To extend the lower stem,

push in the spring lock, pull out the lower stem and

let the spring lock snap into another hole.

3. If you will be using the 1280-X on the handle, and

not body mounted, wind the search coil cable

around the handle assembly as shown in the

diagram above. Secure the cable with the two

Velcro straps included with your 1280-X. Make sure

there is some slack at the control housing end and

enough slack at the other end to attach the search

coil.

4. Remove the Delrin bolt and nylon wing nut from

the search coil. Line up the hole in the stem

between the two holes in the search coil “ears”.

Attach the coil to the stem with the bolt and wing

nut and finger tighten.

Derlin Screw and

Nylon Wing Nut

Arm Rest Screws

Adjustable Arm Rest

LED (Light Emitting Diode)

Control Panel

Spring Lock (Not visible)

Upper Stem

Waterproof Headphones

Battery Access Panel

Search Coil Cable

Lower Stem

8-inch Spider Coil

1 2 3 4 5 6 7 8 9 ... 25 26

Brak uwag

Fisher Labs 1280-X Instrukcja Użytkownika Strona 4